|
|
|
—— RapidECU-F3
RapidECU-F3 is a new generation of fuel cell system controller, support fuel cell engine management system control unit, hydrogen management system control unit, intake management system control unit, thermal management system control unit, rapid prototype development and batch matching controller.
• RapidECU-F3 Application Characteristics
It can be used in vehicle controller, fuel cell engine controller, etc.
|
Basic Parameters |
|
Micro processor |
SPC5746R, 32-bit, dual core, Max. 200MHz, hardware floating-point unit, ISO26262 |
|
SRAM 256KB,Flash 4MB,FRAM 64Kb |
|
Power supply |
Power supply voltage 9~32V, 3-channels external hard wire wake-up, support 1-channel CAN FD, specify any ID wake-up |
|
10-channels 5V sensor power supply, 8 -channels 12V sensor power supply |
|
Input |
28-channels of analog input, among which 12-channels of resistance input (passive sensor), 14-channels of 0-5V voltage input, and 2-channels of current input (current input range 0-20mA) |
|
4-channels of switching input, including 2-channels of high effective switching input and 2-channels of low effective switching input |
|
6-channels of frequency input, support signal frequency and pulse width measurement, frequency range of 10Hz~15kHz |
|
3-channel sent signal collection |
|
Output |
5-channels of Peak-Hold bilateral drive (two pins per channel), supporting BOOST, diode with continuous flow, supporting PWM and switching modes, Peak 1~9A, Hold1~3A, software configuration of Peak-Hold current |
|
4-channels high side drive, 4channels rated 1A, peak 3A, support PWM operation mode and switch operation mode |
|
3-channels of PWM signal output, internal 5K resistor pull up to 12V |
8 low-side power drives, among which 5 rated current 3.5A, peak current 6A, with continuous current diode, supporting PWM operation mode and switching operation mode, with short circuit and open circuit diagnosis function;
2-channels rated current 1A, peak current 1.5A, support PWM operation mode and switch operation mode, with short circuit, open circuit diagnosis function,1-channel rated current 1A, support switch operating mode |
3-channels H bridge power drive output, of which 2-channels rated 4A, peak value 8A;
1-channel rated 1.3A, peak 3.2A |
|
Communication |
4-channels CAN, among which 3 can2.0b, ISO11898,1 CAN FD compatible with CAN2.0b |
|
Connector |
TE 121P waterproof connector |
|
Shell |
Cast aluminum housing, surface shot blasting treatment |
|
