|
|
|
| RapidECU rapid prototyping controller supports independent d |
The RapidECU rapid prototyping controller is equipped with a high-performance MPC5634 professional automotive-grade microprocessor. It has an unprecedented high-quality level. The computing power and memory have been greatly improved. It supports floating-point operations without calibration. It adopts a maturely designed aluminum metal casing. , With 121PIN automotive control system commonly used input and output pin resources, and equipped with circuit protection, good sealing, high waterproof and dustproof design, good shock resistance and environmental adaptability, the weight of the highly integrated controller is only 500g, suitable for Vehicle installation and various environmental test requirements.
Application areas:
Supports rapid prototyping of various automotive electronic control system controllers, such as automatic transmission TCU, hybrid electric vehicle HCU, pure electric vehicle VCU, battery management system BMS, vehicle controller VMS, anti-lock braking system ABS, etc.
The basic parameters are as follows:
|
Basic parameters |
|
Supply voltage |
Normal working voltage 9V~32V, peak voltage 40V |
|
Operating temperature |
-40℃~+85℃ |
|
Circuit protection |
All input and output interfaces have short-circuit protection against ground and battery positive, and the power interface adopts main relay protection |
|
Protection level |
Dustproof and waterproof grade IP65, climate environment protection conforms to ISO16750-4, chemical environment protection conforms to ISO16750-5 |
|
Mechanical strength |
Vibration, shock and drop test comply with ISO16750-3 |
|
shell |
Material aluminum, external dimensions 200mm×180mm×40mm |
|
Connector |
121-pin AMP connector |
|
weight |
500g |
|
Main processor |
|
processor |
MPC5634, 32-bit, clocked at 80MHz, hardware floating point unit |
|
Memory |
Flash 1.5MB，SRAM 94KB |
|
CAN |
2 channels, in line with CAN2.0B, ISO11898 |
|
Program flash |
Bootloader based on CAN bus |
|
