|
|
|
—— RapidECU-F2
RapidECU-F2 is a new generation of fuel cell system controller, support fuel cell engine management system control unit, hydrogen management system control unit, intake management system control unit, thermal management system control unit, rapid prototype development and batch matching controller.
• RapidECU-F2 Application Characteristics
It can be used in vehicle controller, fuel cell engine controller, etc.
|
Basic Parameters |
|
Micro controller |
SPC5746R, 32-bit, dual core, Max. 200MHz, hardware floating-point unit, ISO26262 |
|
SRAM 128KB,Flash 2MB,FRAM 64Kb |
|
Power supply |
9V~32V,3 external hard wire wake-up signal |
|
4-channels of 5V sensor power supply, 2-channels of 12V sensor power supply |
|
Input |
24-channels of analog input, including 10-channels of resistance input (passive sensor), 2-channels of 0~12V voltage input, 22-channels of 0~5V voltage input (including 10-channels and resistance input multiplexed pin) |
|
22-channels of switching input, including 16-channels of high-effective switching input and 6-channels of low-effective switching input |
|
6-channels of PWM frequency input, support signal frequency measurement and pulse width measurement, frequency range of 10Hz~15kHz, high level voltage range of 3.3V~32V |
|
Output |
5-channels of Peak-Hold bilateral drive (two pin in each channel), supporting BOOST, diode with continuous flow, supporting PWM and switching modes, Peak 1~7A, Hold 1~3A, software configuration of Peak-Hold current value |
|
15-channels low side drive: 1-channel rated current 0.7A, switch operating mode; 5-channels rated 4A, peak value 8A, with continuation current diode, support PWM working mode and switch working mode, support current feedback; 6-channels rated 0.4A, peak value 0.8A, switch operating mode; 2-channels rated 0.4A, peak 0.8A, with continuous flow diode, supporting PWM and switching working modes; 1 channel rated 1A, peak 3A, support PWM operation mode and switch operation mode |
|
6-channels high-side drive, rated 1A, peak 3A, support PWM operating mode and switching mode (among which 2-channels and H-bridge power drive output multiplexed pin) |
|
Power drive output of 2-channels H-bridge, rated 1A, peak 2.8A |
|
Communication |
4-channels CAN, CAN2.0b, ISO11898, 3-channels with 120R terminal resistance, 1-channel without terminal resistance |
|
Environment |
Protection class: IP67, working temperature: -40℃~+105℃
The protection of climate and environment conforms to ISO16750-4 and the protection of chemical environment conforms to ISO16750-5
Vibration, impact and drop tests conform to ISO16750-3 |
|
EMC Features |
|
ESD |
Air ELECTROSTATIC discharge test and contact electrostatic discharge test meet the relevant requirements of ISO 10605-2008 |
|
BCI |
Electromagnetic radiation immunity conforms to the relevant requirements of GB/T 17619-1998 |
|
CE |
The related requirements of conducting disturbance are in line with 2008f GB/T 18655-2010 |
|
RE |
Radiation harassment complies with the relevant requirements of GB/T 18655-2010 |
|
CI |
The transient conduction immunity along the power line conforms to the relevant requirements of ISO 7637-2:2004 |
|
